A lot more than 50% of the compression and pumping systems over 3 MW require a variable-speed drive. Variable Speed Gearbox Frequently medium-voltage motors fed by frequency converters and parallel shaft gears are selected. Others are using epicyclic gears with a hydrodynamic superimposition drive.

Taking benefit of the condition of the artwork in electric motors and frequency converters, the driving system for the superimposition of the planet carrier is founded on a Long term Magnet Synchronous Superimposition (SI) motor and an Active Front-End Cycle Converter. So – E stands for Electric.
That is a high-speed gear drive system incorporating elements that allow the utilization of a low-cost constant-speed (electric) driver for a variable-speed application.

More than 50% of the compression and pumping systems above 3 MW need a variable-speed drive. Frequently medium-voltage motors fed by frequency converters and parallel shaft gears are chosen. Others are using epicyclic gears with a hydrodynamic superimposition drive.
It started with hydraulic fluid couplings generating slippage with results not much much better than the throttle.
The design of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Adjustable Frequency Drives (VFD) were developed and, simultaneously, the cost of the shaft trains increased, therefore did efficiency. The problem of THD (Total Harmonic grid Distortion) rose and kept VFD out of several applications.

Taking benefit of the state of the artwork in electric motors and frequency converters, the driving program for the superimposition of the planet carrier is based on a Long lasting Magnet Synchronous Superimposition (SI) engine and a dynamic Front-End Cycle Converter. Therefore – E means Electric.
That is a high-speed gear drive system incorporating components that allow the use of a low-cost constant-speed (electric) driver for a variable-speed application.

All of the over plots were taken by analyzing the existing to the engine. In a normal circumstance, the vibration will end up being monitored and stored on a periodic basis. If the 360 Hz signal is present in the vibration spectrum, it is not normally of any concern. If, however, additional unexplained frequencies appear in the vibration spectra, after that it might be advisable to have a look at both the current waveform and the current spectrum. In the webpages that follow, a few examples of problems found out in DC drives and motors are presented.”
It started with hydraulic fluid couplings producing slippage with results not much much better than the throttle.
The look of hydraulic clutches then improved and included a torque converter and a superimposed epicyclic drive.
Adjustable Frequency Drives (VFD) were developed and, at the same time, the cost of the shaft trains increased, and so did efficiency. The problem of THD (Total Harmonic grid Distortion) rose and held VFD out of several applications.