SMR Gearbox Set up
Satisfactory functionality will depend on right set up. lubrication and maintenance. as a result it is vital that the 
instructions within the set up and servicing leaflet. provided with each and every gearbox. are followed carefully. a few of the essential facets of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as near on the reducer probable, and mount reducer on driven shaft as shut to bearing as sensible. failure to try and do this will trigger extra loads during the input shaft bearings and output bearings and could trigger their premature failure.
two. Install motor and wedge belt drive with the belt pull at about 90° to the center line amongst driven and input shafts. this will allow tensioning with the wedge belt drive with all the torque arm which should really ideally be in tension. if output hub runs anti-clockwise. torque arm really should be positioned the ideal.
3. lnstall torque-arm fulcrum on a rigid support in order that the torque-arm are going to be at somewhere around right angles to the center line with the driven shaft along with the torque arm case bolt. make sure there exists ample take up inside the turnbuckle for belt tension adjustment.
Continue to keep shut.
Bell drive can be positioned in any easy postion. in case the torque arm is usually to be applied to tighten the belts, the drive should be at about tight angle on the line amongst the input and output shafts.
Bell drive may very well be positioned on the appropriate if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite path to that shown during the illustration.
Torque arm and belt consider up.
Torque arm may be mounted to your suitable if sought after.
SMR Gearbox Set up
Tags: