Power UNITS FOR LIFT TABLE 1
Standard Description
This electrical power unit is built solely for the smaller lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit is widely applied inside the business of logistic devices including minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve with the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Standard Description
This power unit is built exclusively for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and the pace controlled through the adjustable needle valve. When the lift rises to a large positoin, however the electrical power provide is cut, the lowering motion is managed through the manual override function.
Energy UNITS FOR LIFT TABLE three
Common Description
This energy unit is designed solely to the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and also the speed controlled by a strain compensated flow control valve.
Energy UNITS FOR LIFT TABLE 4
Basic Description
This energy unit is built exclusively for that substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the velocity managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is minimize, the decreasing motion is controlled from the manual override function.
Exclusive Notes
1. This energy unit is of S3 duty cycle, which may only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned in advance of set up of the power unit.
3. Viscosity on the oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
4. Oil altering is needed just after the first a hundred operation hours,afterwards as soon as every 3000 hrs.
five. The electrical power unit proven is built to be mounted vertically.